Jofemar Coffeemar G-250, Technical Manual

Page: 45 / 95

Coffeemar
G-250
// Coffee
MNP116M01GBV00 Date: 09/04/2013 Rev. 1 PAGE 45 OF 95
5.11. Updating the machine program
The control card of the machine has been designed to use flash technology. This allows
you to update the program in the card without needing to remove any part of the
machine, as this task can be done through a 180 degree 5 pin DIN connector in the RS-
232 port. Program updating can be done through a PC or a J-120 reprogramming card
drive.
■ USING A PC
Follow these steps to update the program:
1.
With the machine turned off, connect the PC to the machine using the RS232 cable.
2.
Choose the program to install in flash memory:
•
The program files should be stored in the subdirectory of the hard drive
corresponding to the COFFEEMAR G250 machine.
•
Run the PC program. Choose the menu option FLASH – RECORD -
COFFEEMAR G250 and choose the .BIN file to record.
3.
Turn the machine on.
4.
When the program has been updated, a message will appear on the PC screen
indicating that the flash memory has been successfully recorded.
■ USING THE J-120 REPROGRAMMING CARD DRIVE
Follow these steps to update the program:
1.
Insert the reprogramming card in the desktop card drive, which should be turned on.
2.
Choose the flash recording application:
•
The program files should be stored in the subdirectory of the hard drive
corresponding to the COFFEEMAR G250 machine.
•
Run the PC program. Choose the menu option CARD – RECORD -
COFFEEMAR G250 and choose the .BIN file to record.
3.
Once the card has been recorded, take it out of the desktop card drive and insert it in
the reprogramming card drive..
4.
With the machine turned off, connect the card drive using the machine's 180°, 5-pin
DIN connector.
5.
Turn the machine on. First, the card drive's green LED will light up and then, while the
program is being recorded, the red LED and the green LED will blink.
6.
When the program has been updated, the card drive's green LED will blink. At this
point you can disconnect the card drive from the machine.
■ USING THE EASYFLASH REPROGRAMMING DEVICE
Follow these steps to update the program:
1.
With the machine turned off, connect the EASYFLASH device to the machine using
any of the cables supplied.
2.
As soon as the program is loaded, it will load the data from the file TYPES.DAT for the
machines with which you wish to communicate.