JLG T500J, Service And Maintenance Manual

Page: 86 / 306

SECTION 3 - CHASSIS & TURNTABLE
3-50 3121200
NOTE: Bearing mandrel must be pressed against the lettered end
of bearing shell. Take care that the housing bore is square
with the press base and the bearing/bushing is not cocked
when pressing a bearing/bushing into the housing.
IF THE BEARING MANDREL SPECIFIED IN THE “ TOOLS AND MATERIALS
REQUIRED FOR SERVICING” SECTION IS NOT AVAILABLE AND ALTERNATE
METHODS ARE USED TO PRESS IN BEARING/BUSHING (13) AND (19) THE
BEARING/BUSHING DEPTHS SPECIFIED MUST BE ACHIEVED TO INSURE ADE-
QUATE BEARING SUPPORT AND CORRECT RELATIONSHIP TO ADJACENT COM-
PONENTS WHEN ASSEMBLED.
BECAUSE THE BEARING/BUSHINGS (13) AND (19) HAVE A PRESS FIT INTO THE
HOUSING THEY MUST BE DISCARDED WHEN REMOVED. THEY MUST NOT BE
REUSED.
2. The Torqlink™ inner housing bearing/bushing (13) can
now be pressed into its counterbore in housing (18)
flush to 0.03 inch (0.76 mm) below the housing wear
plate contact face. Use the opposite end of the bearing
mandrel that was used to press in the outer bearing/
bushing (19).