113161-14
01422 822282
33
5. Make a complete operational check of
ALL
operating controls.
NOTE:
If computer program changes are required, refer to the computer programming section of the
manual supplied with the dryer.
6. The dryer
should be
operated through one (1) complete cycle to ensure that no further adjustments are necessary
and that
ALL
components are functioning properly.
BASKET (TUMBLER) COATING
The basket (tumbler) is treated with a protective coating. We suggest dampening old garments or cloth material
with a solution of water and nonflammable mild detergent and tumbling them in the basket (tumbler) to remove this
coating.
7. Check the electric service phase sequence (3-phase [3ø] models only). While the dryer is operating, check to
see if the blower wheel (impellor/fan) is rotating in the proper direction. Looking from the front, the blower
wheel (impellor/fan) should spin in the clockwise (CW) direction. If it is, the phasing is correct. If the phasing
is incorrect, reverse two (2) of the three (3) leads at connections L1, L2, and L3 of the power supply to the
dryer.
IMPORTANT:
If the blower wheel (impellor/fan) is rotating in the wrong direction, this
will
not
only drastically reduce drying efficiency, but it can also cause premature component
failure.
K. PREOPERATIONAL INSTRUCTIONS
COIN MODELS
Microprocessor Controller (Computer)
1. When the microprocessor controller (computer) is in the ready state, the liquid crystal display (L.C.D.) screen
will display “Ready, Insert $XX.XX (amount) to Start”.
2. Insert coin(s). Once the correct “Amount to Start” has been inserted, the L.C.D. will display “Select
Temperature”.
3. Select temperature by pressing “HI,” “MED,” or “LO.” The cycle will start and the L.C.D. will display the
Dry Cycle selected and the remaining time.
4. The dryer will continue through the drying and cooling cycles, until the vended time has expired.
NOTE:
To stop dryer, open main door or press the pause key. Continuation of the cycle will resume
only after the door has been closed and any of the three (3) temperature selection is pressed.
5. Upon completion of the drying and cooling cycles, the tone (buzzer) will sound and the dryer will go into the
Anti-Wrinkle Mode for 99 minutes, or until the main door has been opened.
IMPORTANT:
For more detailed information regarding the microprocessor controller (computer)
on the dryer, refer to the microprocessor user’s manual included with the dryer.
