PAGE 78 of 185
6.
Mount the yoke to the opposite side of the base using the supplied 3 mm hex
driver
(Fig. 189)
.
TIP:
Keep the yoke level with the base as to ensure no conflicts with the
plunger/set screw attached to the yoke.
7.
Locate the recessed M3 screw
(stop post)
on the bottom of the probe holder.
Unscrew the stop post using a 1.5 mm hex wrench until it has cleared all
obstructions. Do not remove stop post
(Fig. 190)
.
8.
Raise the stop post on the opposite side until the side of the post clearly
contacts the 90° stop point on the probe holder’s base
(Fig. 191)
.
Fig. 189 - Screw yoke to opposite side
Fig. 190 - Lower 90° stop post
Fig. 191 - Raise opposite 90° stop post
Fig. 192 - Reversed probe holder