6. WORKING IN THE FIELD
PIGB-206X-02 FCT1460 0614
- 79 -
The rotor
In case of blockage in the rotor, immediately change to neutral position and turn off
the power transmission. Hereby the auger and the feed intake stop immediately, and
you can obtain an overview of the situation.
To enable the feed rollers to pull the material out of the rotor, it must be disconnected
during reverse. The procedure is as follows:
1)
Go to the machine when the power take-off has been disconnected and the engine
has stopped.
DANGER:
Do not approach the machine until the rotating parts have come
to a complete stop and be aware that neutral position does not
guarantee that the feed intake will not start.
Fig. 6-7
2) Move the PTO shaft
A
for the rotor to the alternative pin in
pos. 1
, where the
Fig. 6-8
gear wheels are not in mesh. Thereby the rotor is not driven.
WARNING:
It is important that the PTO shaft is NOT moved to pos. 2, where
the rotor rotates in the opposite direction. This position is only
used for grinding.
3) Connect the power take-off again at low number of rpm, move the reverse
function to reverse position and reverse the material out of the machine.
Fig. 6-7
4) After reversing disconnect the power take-off again, and when the rotor has
come to a complete stop, move the PTO shaft
A
for the rotor back to the pin
B
for driving the rotor.
5) With the reverse function in neutral
it is now normally possible
to ”blow” the
chopped grass, which is in the rotor housing, out of the chute, unless this is also
blocked.
In order to ”blow the rotor housing empty” it is necessary to increase
the number of revolutions to maximum.
6)
Move the reverse function back to normal feed intake, and the work can be
resumed.
Fig. 6-7
P
R
1
2
-0
4
6
0
A
B
Fig. 6-8
Summary of Contents for FCT King Size 1260
