JF FCT King Size 1260, Directions For Use Manual

Page: 109 / 114

12. MISCELLANEOUS
PIGB-206X-02 FCT1460 0614
- 109 -
Problem Possible cause Remedy
The machine does not react
to the control box. 1) The control system is not
turned on.
2)
There is no oil flow.
1) Turn on the control
system.
2) Establish constant oil
flow from the tractor.
It is not possible to adjust the
reverse system to position for
normal feed in after reversing. There is a fault on the contact
element at the nylon disc on the
automatic clutch. The contact
element must reset the electric
system after reverse so that the
machine can work again. Replace the contact element on
the automatic clutch.
Although normal feed intake
position is established, the
pawl is still in mesh. Error in the wire for the coil. Repair or replace the wire.
Metal is detected, but there is
no metal in the feed intake
section. 1) The adjustment of the
magnetic field from the
magnet tub has been
changed.
2) There are loose metal parts/
swarf in the roller which
disturb the magnetic field.
3) The voltage supply from the
tractor is not sufficient. The
MD system "regards" reduced
voltage drop (under 8 V) as a
disturbance, i.e. metal
detection.
1) Dismount the magnet tub and
send it to Kongskilde where it
will be adjusted.
2) Clean the roller and the tub
of loose metal parts/swarf.
3) Check if the voltage supply
from the tractor is correct
–
12 V.