JF FCT King Size 1260, Directions For Use Manual

Page: 31 / 114

2. CONNECTION TO TRACTOR
PIGB-206X-02 FCT1460 0614
- 31 -
DRAWBAR AND PTO DRIVE SHAFT
The hitch eye of the drawbar is intended for a 30 mm hitch pin. The hitch pin must be
secured. The drawbar load is 660kg.
Fig. 2-10 Adjust the length of the PTO shaft so that it:
- in working position has minimum 200 mm overlap, see measure
b .
- is not compressed more than the prescribed 30 mm in order not to bottom the shaft,
see measure
a .
Adjustment of the length can take place by pulling out or pushing in the drawbar of
the tractor.
Fig. 2-11 The height H of the hitch eye must be adjusted so that the PTO shaft is horizontal.
The height can be changed by moving or turning the drawbar bracket.
To ensure longest possible life of the PTO shaft the following applies to standard
PTO shaft without wide angle: The length
L1 must be equal to the length L2 , i.e. the
centre of rotation P for the drawbar must be as close as possible under the centre
between the joints. The drawbar bracket on the chopper can be moved back and
forth in steps of 25 mm.
IMPORTANT: The drawbar must always be mounted and fastened with 2 bolts.
Fig. 2-10
P
R
1
1
-5
0
1
7
Fig. 2-11