5
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
This information is intended to allow
the user to make a better estimation
of the hazards and risks involved.
4.3 Content of delivery
Slow speed wet sharpener
Stone wheel Ø200mm, 250 grit
Leather honing wheel Ø180mm
Water tank
Support arm
Straight edge jig
Stone grader
Honing compound
Angle measuring device
Existing angle measuring device
Operating manual
Spare parts list
DVD
4.4 Machine description
Fig 1
A….Leather honing wheel
B….Carrying handle
C….Stone wheel
D….Torque adjust knob
F….Water tank
G….Support arm
H….Speed adjust knob
I…...ON/OFF switch
J…..Rubber feet (4)
Fig 2
P….Straight edge Jig
Q…Stone grader
R…Honing compound
S….Angle measuring device
T…Exist angle measuring device
Fig 3
5. Transport and start up
5.1 Transport and installation
The machine is designed to operate in
closed rooms and must be placed
stable on firm and levelled surface.
The machine can be bolted down if
required.
For packing reasons the machine is not
completely assembled.
5.2 Assembly
If you notice any transport damage
while unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with a
mild solvent.
Mount the stone wheel:
Install the stone wheel (C) on the shaft
(K).
Place a washer (L) on each sides of the
stone wheel and tighten the nut (M).
Fig 4
Note:
For your convenience the stone wheel
has already been trued at the factory.
This gives you a good stone runout
right from the start.
Mount the water tank:
Install the water tank (F) on the side of
the machine.
Fill the water tank with water up to
the “MAX” marked water level.
Note: The stone will soak up a lot of
water (approximately 0,5 litre) in the
first 15 minutes.
When the stone wears down to a
smaller diameter the second (upper)
mounting position has to be chosen.
Mount the support arm:
Install the support arm (G) to the
machine.
Depending on the sharpening job it
can be installed in different positions.
Storage:
The existing angle measuring device
(T) will stick to the magnets on the
designated place at the side of the
machine.
The angle measuring devise (S) has
integrated magnets and will stick to
the machine body at any place.
