JC BORDELET EVA992GAZ, Instructions For Installation, Maintenance And Use

Page: 6 / 26

INSTALLATION OF THE BASE
Place the base on a flat floor. The appliance has 4 height-
adjustable feet.
Please make sure to comply with distances from inflammable
materials as provided in the technical characteristics and
make sure that the appliance is in the correct position before
installing the base.
Caution, the foot screws will no longer be easily accessible
once the fireplace is mounted on the base.
A 10mm minimum distance between the base and the
floor must be kept to ventilate the appliance.
INSTALLING THE FIREPLACE ON THE BASE
Be careful not to damage the gas system mounted on the
base when installing the fireplace.
The fireplace must be oriented according to the 2 marks, one
on the base of the fireplace and one on the base plate.
Bolt the fireplace to the base using the 3 x 15mm-long M6
bolts.
Before continuing the installation, it is necessary to make
sure that the pressure relief valve can move freely.
In order to do so, lift it several times to the maximum from
the outside of the fireplace.
Warning: the data plate attached to the burner thermal shield
with a small chain must remain accessible.
DETERMINING THE FLUE CONFIGURATION
Make a diagram of the desired layout of the concentric flue
system.
Respect the required distances from flammable materials and
the position of permitted outlets as described below when
positioning your appliance
Make sure the layout is permissible from a technical point of
view based on the tables of paragraph: “How to calculate the
deflector position” . If it is not, an alternative layout must be
determined.
Attention, depending on the layout, the appliance will use
either POUJOULAT DUOGAS Ø130/200 flue ducts for C11
configuration, or POUJOULAT DUOGAS Ø100/150 flue
ducts for C31 or C91 configuration.
PREPARATION OF THE GAS AND ELECTRICITY SUPPLY
POINTS
The appliance may be connected to the gas and electricity
supplies inside the base, or outside for wall-mounted
appliances. When connecting inside the base, leave a certain
amount of space free. This is required to accommodate the
solenoid valve block, the flame controller and the receiver.
We recommend that you provide the gas supply and the
electrical connection on the front of the base. This will allow
easy access for any intervention subsequent to the
installation of the device.
REMOVING THE FIREPLACE’S GLASS SCREENS
Before commencing installation of the appliance, the
fireplace’s glass screens must be removed.
To do this, remove the top and bottom fastenings and set
them aside for later.
Glass screens must be handled carefully using gloves.
The dismantled glass screens must be placed on a soft
surface away from people.
Even a small chip can quickly lead to a crack or even a
broken glass.
INSTALLATION OF THE APPLIANCE
Top fastenings
Glass screens to be removed
(x4) for free-standing appliance
(x3) for wall-mounted appliance
Bottom
fastenings
Hearth mark
Base mark
Top view
435mm
1
7
0
m
m
Free space
Solenoid
Preferred
position of air
inlets
Pressure release valve
Base hatch
1. INSTALLATION INSTRUCTIONS