JC BORDELET EVA992GAZ, Instructions For Installation, Maintenance And Use

Page: 17 / 26

The following programs are available*:
- A program with identical settings for each day
- A program with different settings for the days of the week
and for the weekend.
- A program with different settings for each day
The program is easy to enter: just set the start time and the
desired temperature for each period.
As the gas fireplace is a supplementary heating system, the
remote control that houses the temperature sensor must be
kept at a distance of more than 1.5 m from the fireplace.
The fireplace must have been previously installed and
connected to the gas supply network, the exhaust network,
the combustion air supply and the mains network.
Here in this case, it must be connected to the 220/240V AC
50/60Hz mains supply.
Inserting batteries in the remote control
Before using the remote control you must insert the two AA
batteries (supplied). Once the batteries have been inserted,
the remote control is ready for manual use and manual flame
height adjustment. In order to save battery power the display
turns off shortly after the last button press, unless the
fireplace is turned on.
•
The factory setting for the timer is 15 minutes
Flame symbol
The appliance is designed to create attractive yellow flames.
The flame symbol indicates that your fireplace burner is on
and flame monitoring is active.
Communication with the remote control
The remote control can only communicate with the fireplace
appliance when it has been recognized by the appliance’s
receiver.
If both appliances are turned on, registration is done
automatically within a matter of minutes. This step is called
"bnd"
USING THE REMOTE CONTROL
USING THE REMOTE CONTROL
The remote control has been specifically designed to work
with the gas inflow control system in your appliance. It has
been adjusted by us to ensure your fireplace works correctly.
The instructions below must be read before using the remote
control unit or the fireplace.
ECRAN ET COMMANDES
DISPLAY
CONTROLS
TURNING ON
The remote control lets you control your FIREPLACE
“manually” or using the programmer*. You can adjust the
temperature and the height of the flames manually.
The programmer only regulates the temperature.
Display
Increase button
Decrease button
Stop / Standby button
Menu button
Manual operation
Programmer activated
Active programmer period
Fireplace closed (left) or open (right)
The fireplace is lit
The fireplace can be lit
Fireplace malfunction: it had to be reset
Low burner setting (left), high burner setting (right)
Operation in progress (e.g. ignition of the fireplace)
Malfunction
Fireplace is incorrectly plugged in to the mains
Radio Frequency (RF) communication
Low battery level (the symbol is flashing)
Time display (12 hour or 24 hour
Days of the week (the square indicates the current day)
Temperature display
Temperature sensor malfunction
Increase the setting or change the selection
Decrease the setting or change the selection
Choose menu and selection
Exit the setting menu or go into standby mode
+
+
This screen is shown during
registration.
The symbol will flash. When
registration is complete, the startup
screen appears.
This screen appears when the
remote control is not registered. The
symbol will flash. Switch on
the fireplace within 5 minutes and
register as follows: press the and
buttons simultaneously
2. MAINTENANCE AND USE INSTRUCTIONS