JC BORDELET EVA992GAZ, Instructions For Installation, Maintenance And Use

Page: 18 / 26

Adjusting the flame height
Press the or button once. The screen below will
appear.
Wait a few seconds or press the button to exit the menu.
Turning off the fireplace
Press the button to turn off the fireplace.
Adjusting the temperature
The fireplace turns on and off automatically based on heating
requirements. Press the and buttons to select the
desired temperature. The screen shown below will appear.
Wait a few seconds or press the button to exit the menu.
Temporary bypass of the temperature setting
The temperature adjustment function also lets you
temporarily turn off the fireplace.
Press the button to turn off the fireplace.
N.B.: the temperature cannot be changed when the
temperature setting function is bypassed.
The current temperature flashes. Select
the desired temperature using the
and buttons. Depending on the
button used, the symbols or
appear on the screen. The temperature
can be set to a value between 5.0 and
35.0 ° C
The symbol flashes, indicating
that the hotplate must be turned on
manually by simultaneously pressing the
and buttons.
As soon as the fireplace is turned on
again, the temperature adjustment
function is reactivated.
If the fireplace, the receiver or the remote control are
replaced, the remote control must be registered manually,
see Procedure for remote control recognition.
Setting the day and time
Le programmateur de la télécommande est disponible
uniquement si l’heure est réglée. Le réglage du jour et de
l’heure s’effectue à partir du menu
Utilisateur , voir Réglage
du jour et de l’heure
Vous pouvez régler l'affichage du temps, sur 12 ou 24 heures,
à partir du menu Installation, voir Affichage sur 12 ou 24
heures.
USING THE REMOTE CONTROL
The remote control has a screen and four buttons. It provides
easy control of the fireplace. The settings can also be easily
changed.
There are two adjustment menus:
- Use menu
- Installation menu
Press the menu button to select the User menu or press
and hold the menu button for ten seconds to select the
Installation menu
Manual operation
Depending on the settings selected in the User menu, the
temperature or flame height can be set manually.
Adjusting the flame height
The fireplace is lit and turned off manually
Lighting the fireplace
*Depending on your fireplace’s factory settings, the menu
button may not react with a single press, but must be held
down for 2 seconds.
The operational self-checking procedure is symbolized by the
hourglass . The temperature displayed is that measured
by the probe in the remote control.
If the flame does not light or is not detected, the flame
symbol will flash. To reset the box, press the stop button
Simultaneously press the and
buttons when the screen opposite
appears.
The screen shown opposite will appear.
The and symbols flash, indicating
that the fireplace has been turned on.
As soon as the fireplace is lit, the screen
shown below appears.
You can now manually adjust the flame
height.
The flame height setting will flash.
Adjust the desired height using the
and buttons.
Depending on the button pressed, the
or symbol will be displayed.
The flame height is set on a scale from
1 to 15
The screen opposite will appear. The
symbol will flash, indicating that the
fireplace has been turned off. Once it is
turned off, the startup screen appears
again.
The screen shown opposite will appear.
The symbol will flash, indicating that
the fireplace has been turned off. Once
it is off, the screen shown below
appears.
USING THE REMOTE CONTROL
2. MAINTENANCE AND USE INSTRUCTIONS