Janome AT2000D, Instruction Book

Page: 29 / 65

26
Threading Loopers with the Looper Threading
Wire or Standard Thread
If the looper threads are made from materials that are
difficult to thread, such as wooly nylon, there are 2
ways to thread the looper threads:
• Use the looper threading wire (looper threader)
• Tie the thread to standard thread, which you then
use to thread.
q
q
w
e
r
t
t
z x
c
v b
n m
,
CAUTION
Turn the power switch OFF before threading the
machine.
Using the looper threading wire
z
Pass the thread up to the looper thread guide (before
the looper threader hole).
x
Set the looper threader switch lever to the
“THREADING” position.
q
Looper threader switch lever
c
Turn the handwheel toward you slowly until it clicks.
This locks the handwheel in place.
w
Handwheel
v
Pass the straight end (not the loop end) through the
looper threader hole until it comes out from the the
hole of the looper tip.
e
Loose end of looper threading wire
r
Looper threader hole
b
Pass approximately 2˝ (5 cm) thread through the loop
of the looper threading wire.
t
Thread
n
Pull the loose end of the looper threading wire until
the thread comes out from the hole of the looper tip.
m
Remove the thread from the looper threading wire.
,
Return the looper threader switch lever to the
“SEWING” position.
CAUTION
Do not raise or lower the looper thread lever while
threading.