Janome AT2000D, Instruction Book

Page: 23 / 65

20
Looper selection lever
Turn the looper selection lever to the right to
thread the lower looper.
Turn the looper selection lever to the left to
thread the upper looper.
⁄0
Using the tweezers, insert the end of the thread 2 cm
or more into the threading hole on the right.
!2
Tweezers
!3
Threading hole on the right
!4
Thread (30 cm or longer)
!5
Thread end (2 cm or longer)
!2
!3
!4
!5
⁄0
n
Pull out approximately 12˝ (30 cm) of thread. Make
sure that the thread does not get tangled around the
lever or the cover.
i
Thread
m
Set the looper threader switch lever to the
“THREADING” position.
o
Looper threader switch lever
Adjusting the looper threader switch lever
Set the looper threader lever to the
“THREADING” position by turning it to the
right.
Set the looper threader lever to the “SEWING”
position by turning it to the left.
i
o
n m
!0
,
.
!1
n m
,
⁄0
.
,
Turn the handwheel toward you slowly until it clicks.
This locks the handwheel in place.
!0
Handwheel
.
Turn the looper selection lever to the “LOWER LOOPER”
position.
!1
Looper selection lever
NOTE:
• Trim the thread end so that it can be inserted into
the threading hole smoothly.
• If threading special threads, such as wooly nylon,
etc., refer to pages 26 and 27.