Janome AT2000D, Instruction Book

Page: 24 / 65

21
⁄1
Raise the looper threader lever until it clicks into
place.
!6
Looper threader lever
!6
⁄1
!6
⁄2
!7
!8
!9
@1
@0
⁄3
⁄4
@2
⁄5
o
⁄2
Lower the looper threader lever until it knocks into
place.
⁄3
Make sure that the thread comes out from the hole of
the lower looper tip.
!7
Thread end
!8
Hole of lower looper tip
* If the thread does not come out from the hole,
follow the procedure from step
⁄1
again.
* If the thread comes out behind the pipe, use the
tweezers to draw the thread toward you between
the lower looper and the pipe.
!9
Thread (behind the pipe)
@0
Pipe
@1
Lower looper
⁄4
Draw 4˝ (10 cm) of the thread under the toe of the foot,
and pull it to the rear between the foot and the upper
knife.
@2
Upper knife
⁄5
Return the lower threader switch lever to the “SEWING”
position.
o
Lower threader switch lever
Close the looper cover and lower the presser foot
lifter.