janitza UMG 96 RM-E, User Manual And Technical Specifications

Page: 56 / 126

56
UMG 96RM-E
Manual setting of the subnet mask (SUb)
• When in the programming mode, press button 2 to get
to the subnet mask settings (SUb display).
• Use button 1 to select the desired digit and set
it by pressing button 2. Repeat this step for each digit
in bytes 0 to 3 in a way similar to setting the TCP / IP
device address.
• After repeated display of byte 0 (
no digit is flashing)
one can set the gateway address.
Manual setting of the gateway address (GAt)
• When in the programming mode, press button 2 to get
to the gateway address settings (GAt display).
• Press buttons 1 and 2 to set the desired gateway
address in bytes 0 to 3 as described above.
Disable the dynamic IP allocation (dYN IP, oFF) to ensure
that the manual settings of the TCP / IP device address,
subnet mask and gateway address are not overwritten
by a DHCP server.
Dynamic IP allocation (dyn)
The dynamic allocation of the TCP / IP settings (device/
gateway address and subnet mask) provides for a fully
automated integration of the device into an existing
network with a DHCP server. TCP / IP settings do not
need to be configured manually as they are automatically
assigned by the DHCP server when the device is started.
Addresses are read out in the programming mode
the same way as in the manual settings.
• Switch to the programming mode as described.
The symbols for the programming mode PRG
and the current transformer mode CT appear
on the display.
• Press button 2 several times to display the dynamic IP
allocation (dYn IP).
• Press button 1 to enable the parameter "on" or "oFF"
(parameter is flashing).
• Press button 2 to select the parameter and confirm
by pressing button 1. Exit the programming mode
or wait about 60 seconds.
C
Changes will only take effect after you exit
the programming mode.
If the key symbol is displayed, the dynamic
IP allocation is enabled.
Device / gateway address and subnet
mask are provided and automatically
accepted by the DHCP server.