46
UMG 96RM-E
Operation
The UMG 96RM-E is operated via buttons 1 and 2 with
the following functions:
• briefly pressing button 1 and 2:
next step (+1)
• pressing and holding button 1 and 2:
previous step (-1)
Measured values and programming data are displayed
on an LCD display.
There are
display
and
programming
modes. You can
avoid an unintentional change of programming data
by entering a password.
Display mode
In display mode, you can scroll through the programmed
measured values by pressing buttons 1 and 2. When
the device is delivered, all measured value indications
of profile 1 can be retrieved. For each measured value,
up to three measured values are indicated. The measured
value rotation can display selected measured value
indications one after the other with a selectable changing
time.
Programming mode
You can view and change the necessary settings
of the UMG 96RM-E in programming mode. Press
button 1 and 2 simultaneously for about 1 second
to switch to programming mode after entering
the password. If no password is programmed, you get
directly to the programming mode menu. Programming
mode is marked by the text „PRG“ on the display.
Press button 2 to switch between the following menus:
- Current transformer,
- Voltage transformer,
- Parameter list,
- TCP/IP device address,
- Subnet mask,
- Gateway address,
- Dynamic TCP/IP addressing (in/out).
If no button was pressed for about 60 seconds when you
are in programming mode, or button 1 and 2 are pressed
simultaneously for about 1 second, the UMG 96RM-E
will switch back to display mode.
Summary of Contents for UMG 96 RM-E
Page 121: ...121 UMG 96RM E...
Page 126: ...126 UMG 96RM E...