![background image](http://html1.mh-extra.com/html/jai/viscam-1000-system/viscam-1000-system_installation-manual_3216691046.webp)
VISCAM 1000 Systems
40
Appendix B
6.
Attach the Traffic Light Sensor body to the flange and secure it with
the four screws
7.
Orient the Traffic Light Sensor such that the white reflectors are
parallel to the trigger plane with side B facing (visible from) the
trigger plane
8.
Route the free end of the cable to the VJP-300 J-Panel in accordance
with the local code requirements
9.
Connect the color-coded wires to J-Panel connector X3 as described in
Table 7. Make sure that no power is applied when performing any
wiring operation.
Figure 39.
Installing the TLS-301 through the mounting pipe and flange.
6.3
Connection to TLS-301 Traffic Light Sensor (X3 and X7)
The TLS-301 Traffic Light Sensor connection to the J-Panel is shown in Table 4 and Figure 15.
Note: Connection X15 is no longer used.
Table 7
TLS 301 to J-Panel connections.
X3 Pin #
Signal
Description
Connection to Light Sensor Cable wire color
1
+24V dc
Power output
Red
2
Gnd
Power return
Black
3
D0+
ENET TX+
White/orange
4
D0-
ENET TX-
Orange
5
D1+
ENET RX+
White/Green
6
D1-
ENET RX-
Green
Note: TLS-301 cable also includes a drain wire connected internally to the cable shield. The loose
end of this wire should be connected to chassis ground.
Figure 40.
TLS-301 to J-Panel wiring