Configuring the Camera
37
RM/TM-2040GE Series
Figure 22.
ImageSizeControl category
SensorDigitizationTaps:
the camera can be configured to read out from the image sensor using either one or
two channels. Possible options:
•
One: Single Tap. This mode will use one channel to read out images. The image will have a uniform
intensity but results in slower frame rate.
•
Two: Dual Tap. This mode uses two channels to read out images. Since two different electronic channels
are used, the image needs to be balanced by using GainAutobalance and BlackLevelAutobalance.
WidthMax:
shows the current valid maximum value for Width.
HeightMax:
shows the current valid maximum value for Height.
Width:
sets the width of the output image. When ScanMode is changed it is necessary to set this value to equal
to or less than WidthMax.
Height:
sets the height of the output image. When ScanMode is changed it is necessary to set this value to
equal to or less than HeightMax.
OffsetX:
specify the offset from the left edge of the image captured by the sensor to be sent out of the
camera. Width must be set lower than WidthMax before this value can be increased.
OffsetY:
specify the offset from the top of the image captured by the sensor to be sent out of the camera.
Height must be set lower than HeightMax before this value can be increased.
•
Offset Example:
•
ScanMode is set to A_1600x1200
•
Width to 600 and Height to 100.
•
OffsetX can have a range of 0 to 40. OffsetX is then set to 20.
•
OffsetY can have a range to 0 to 80. OffsetY is then set to 35.
Summary of Contents for RM-2040GE Series
Page 1: ...RM TM 2040GE RMC TMC 2040GE Progressive Scan Cameras Document Version E Document P N 10447 ...
Page 2: ......
Page 66: ......
Page 67: ......
