JAI RM-2040GE Series, User Manual

Page: 13 / 68

Installation 11
RM/TM-2040GE Series
When wiring the PD-12UU and PD-12UE power supplies directly, please note the following:
•
The lead ends must be twisted together and tin-soldered for strength and electrical continuity.
•
Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and shorting.
•
The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.
•
All connections must be properly insulated to prevent shorting.
2.2.3 (b) JAI Inc. Power Cables
If you are using JAI Inc. power cables such as the 12P-02S, please refer to the 12-pin connector pin-out diagram
below. The cable pin-out diagram is shown in Figure 51. The color-coded leads use Gray for Ground and Yellow
for +12V.
Figure 3.
12P-02S Interface Cable (optional)
12P-02S Interface Cable
Pin# Lead Color Function
Pin
#
Lead Color Function
1 Gray GND (Power Ground) 7 Black coax TTL IN (External_VD)
2 Yellow +12V DC (Power In) 8 White coax shield TTL OUT (STROBE)
3 Red coax shield GND(Analog Ground) 9 White coax TTL IN (External_HD)
4 Red coax Reserved 10 Brown Reserved
5 Orange coax shield GND(Digital Ground) 11 Blue Reserved
6 Orange coax TTL IN (External_Trigger) 12 Black coax shield Reserved
Note: Make sure that the unused leads are not touching and that there is no possibility that exposed wires
could cause the leads to short.
2.2.3.2 Building Your Own Power Cable
Refer to the 12-pin connector pin-out in Figure1. Connect the Ground lead to pin #1, and the +12V DC lead to
pin #2 of the 12-pin connector. Power must be DC-regulated, and of sufficient current to properly power the
camera.
2.2.3.3 Attaching the Power Cable to the Connector
The 12-pin connector is keyed and will only fit in one orientation. Follow these directions to properly attach
the power cable to the camera connector:
1. Rotate the connector while applying slight pressure until the keyways line up.
2. Press the connector into place until firmly seated.
3. Plug the power cord into the 100V AC socket. This powers-up the camera.