JAI GO-5000C-USB, User Manual

Page: 24 / 70

GO-5000M-USB / GO-5000C-USB
- 22 -
6.5.10 Pulse Generator Inverter
Clear Source Signal can have polarity inverted.
6.5.11 Pulse Generator Setting Parameters
Table – 10 Pulse Generator setting parameters
Display Name Value
Clock Pre-scaler 1 to 4096
Pulse Generator Clock (MHz) [Pixel Generator Tick Frequency: 48MHz]÷[Clock Pre-scaler]
Pulse Generator Selector - Pulse Generator 0
- Pulse Generator 1
- Pulse Generator Length 1 to 1048575
- Pulse Generator Length (ms)
（
[Clock Source]÷[Clock Pre-scaler]
）
-1
x [Pulse Generator Length]
- Pulse Generator Frequency (Hz)
［
Pulse Generator Length (ms)
］
-1
- Pulse Generator Start Point 0 to 1048574
- Pulse Generator Start Point (ms)
（
[Clock Source]÷[Clock Pre-scaler]
） -1
x [Pulse Generator Start Point]
- Pulse Generator End Point 1 to 1048575
- Pulse Generator End Point (ms)
（
[Clock Source]÷[Clock Pre-scaler]
）
-1
x [Pulse Generator End Point]
- Pulse Generator pulse-width (ms) [ Pulse Generator End Point (ms)]
－
[ Pulse Generator Start Point (ms)]
- Pulse Generator Repeat Count 0 to 255
- Pulse Generator Clear Activation
Clear Mode for the Pulse Generators
- Off
- High Level
- Low level
- Rising Edge
- Falling Edge
- Pulse Generator Clear Sync Mode - Async mode
- Sync mode
- Pulse Generator Clear Source - Low
- High
- Acquisition Trigger Wait
- Acquisition Active
- Frame Trigger Wait
- Frame Active
- Exposure Active
- Fval
- Lval
- User output 0
- User output 1
- OPT In
- NAND0 Out
- NAND1 Out
- Pulse Generator Inverter(Polarity)
Pulse Generator Clear Inverter
- False
- True
Note:
1. If
Pulse Generator Repeat Count is set to “0”, the pulse generator works in free-running mode.