JADAK flexpoint™ HS-‐‑1M User’s Manual
Page 63
Maxi Code
Maxi Code Defaults
To set the default values for Maxi Code, scan this code:
Maxi Code On/Off
Scan one of the codes below to enable or disable Maxi Code. Default = Disabled.
Enable
*
Disable
Maxi Code Minimum and Maximum Length
Use the following commands in combination with numerical values to set the minimum
and maximum length for allowed Maxi Code barcodes.
Default minimum length = 1. Default maximum length = 150.
The minimum and maximum length for this symbology can be set either by sending the
serial command shown under the barcodes below with a value between 1 and 150, or
by scanning one of the barcodes below and then set the length by scanning the digit
codes and the SAVE barcode in
Appendix B
.
Please contact JADAK if assistance is needed.
Maxi Code Minimum length
Maxi Code Maximum length
