JADAK flexpoint™ HS-‐‑1M User’s Manual
Page 54
Matrix 2 of 5
Matrix 2 of 5 Defaults
Set all Matrix 2 of 5 settings to their default configuration with this command.
Matrix 2 of 5 On/Off
Scan one of the codes below to enable or disable Matrix 2 of 5. Default = Disabled.
Enable
*
Disable
Matrix 2 of 5 Minimum and Maximum Length
Use the following commands in combination with numerical values to set the minimum
and maximum length for allowed Matrix 2 of 5 barcodes.
Default minimum length = 4. Default maximum length = 55.
The minimum and maximum length for this symbology can be set either by sending the
serial command shown under the barcodes below with a value between 1 and 55, or by
scanning one of the barcodes below and then set the length by scanning the digit codes
and the SAVE barcode in
Appendix B
.
Please contact JADAK if assistance is needed.
Matrix 2 of 5 Minimum Length
Matrix 2 of 5 Maximum Length