JADAK flexpoint™ HS-‐‑1M User’s Manual
Page 24
Aimer Mode
The HS-1M’s imager engine is equipped with an aimer that can help with positioning barcodes
for quicker decoding. Scan one of the following codes to enable or disable the aimer of the
scanner, during decode attempts. Default = Enabled.
*
Enable
Disable
Aimer Delay
The HS-1M’s aimer allows a delay time for the user to aim the engine before actual scanning
begins. During this delay, the aiming light will appear, but the scanner’s illumination won’t
show, until the delay time has passed.
This command sets the Aimer Delay Time in steps of 1 millisecond from 1ms up to 4000ms
(4 seconds). Default = Off.
Several commonly used Aimer Delay menu command barcodes are included below.
If a different delay time other than those provided is needed, it can be set either by sending
the serial command
AIM_DLY x
(where ‘x’ is a value between 0 and 4000), or by
scanning the top barcode below and then set the time by scanning the digit codes and
the SAVE barcode in
Appendix B
. Please contact JADAK if assistance is needed.
Sample settings:
* Aimer Delay Off
Aimer Delay = 500ms
Aimer Delay = 1000ms
Aimer Delay = 2000ms
