JADAK flexpoint™ HS-‐‑1M User’s Manual
Page 27
Trigger Commands
In order to scan barcodes, you need to send a trigger command. This can be done in
various ways. You can activate the HS-1M by sending the trigger command
TRGON,
pressing the physical trigger button or by using the trigger line/pin of the cable.
Several supporting commands are provided to set the allowed trigger time-out (e.g. the
maximum time that the scanner will take to keep looking for a barcode) on the next page.
TRGON
This command turns the trigger ON.
TRGOFF
This command turns the trigger OFF.
Trigger Modes
Manual Trigger (level)
You can activate the HS-1M by pressing the trigger or sending the serial trigger command
TRGON
. When in manual trigger mode, the HS-1M scans until a bar code is read, until
the trigger is released, or the trigger time-out occurs.
Use the command below to enable Manual Trigger Mode.
* Manual (level) Trigger
Presentation Mode
Presentation mode is a hands free mode of operation in which the HS-1M will
automatically trigger on when an object is moved into the field of view.
The HS-1M will not enter low power mode while in presentation mode.
Use the command below to enable Presentation Mode.
Presentation Mode