9 MAINTENANCE
en-59
9.14 TIRES ___________________________________________________________________
Keep the tires correctly inflated to increase tire life. Inspect the tread wear.
Check the tire pressure each day, while the tires are cool. Use an accurate low-pressure tire gauge.
Keep tires inflated to 16 psi (1.11 BAR) for the front tires, and 12 psi (0.86 BAR) for the rear tires.
9.15 WHEEL MOUNTING PROCEDURE____________________________________________
Remove dirt, grease and oil from the stud threads. Do not lubricate
threads.
Put the wheel on the hub. Inspect the wheel to make sure of full contact
between surface of wheel and hub.
Tighten all hardware with your fingers, then torque hardware in the order
shown. When possible, tighten nuts in the top position.
Check and torque hardware each day until torque is kept at 85-95 ft.lb.
(115-128Nm).
9.16 ROPS ___________________________________________________________________
A Roll Over Protective Structure (ROPS) is included with this mower. Inspect the ROPS periodically for loose hardware
or damage.
Every 400 hours, inspect the seat, seat belt, ROPS mounting hardware and ROPS frame for damage. Replace all
damaged parts immediately. All replacement parts for the ROPS must be as specified in the Parts Manual.
Check and torque all ROPS hardware every 100 hours.
CAUTION
DO NOT try to put a tire on a rim unless you have the correct training, tools and experience. Incorrect mounting can
cause an explosion which can cause injury.
WARNING
Make sure the mower is parked on a solid and level surface. Never
work on a mower that is supported only by the jack. Always use jack
stands.
If only the front or behind the mower is lifted, put the chocks in front
of and behind the wheels that are not lifted.
CAUTION
Keep the ROPS hardware correctly fastened. Do not do welding operations, drill, change or bend the ROPS.
Replace damaged ROPS. Do not try to correct a damaged ROPS.
!
1
2
3
4
1
2
3
4
5
Front Wheel
Torque Order
Rear Wheel
Torque Order
!
!
Summary of Contents for HR-9016 Turbo
Page 13: ...SPECIFICATIONS 4 en 12 K L D B A P P N C J H M E G...
Page 28: ...5 DECALS en 27...
Page 90: ...13 NOTES en 89 13Notes...
Page 91: ...NOTES 13 en 90...
