Iveco N60 ENT M37, Technical And Repair Manual

Page: 184 / 194

TIGHTENING TORQUES
Marine parts tightening torques
Part Torque
Nm kgm
M10 Nut turboblowers fixing on exhaust manifold 43 ± 6 4,3 ± 0,6
M10 Lock nut fixing turboblowers on exhaust manifold 26 ± 10 2,6 ± 0,1
M8 x 115 Screw for air-air or water-water exchanger 18 ± 2 1,8 ± 0,2
M8 x 120 Screw for air-water heat exchanger 18 ± 2 1,8 ± 0,2
M12 x 30 Screw for front engine support legs 69 ± 7 6,9 ± 0,7
M12 x 30 Screw for back engine support legs 66 ± 7 6,6 ± 0,7
M6 x 20 Screw for cooled Riser stub pipe 8 ± 1 0,8 ± 0,1
M10 Nut anchoring the alternator 43 ± 6 4,3 ± 0,6
M10 x 140 Screw fixing the pump water inlet pipe and support bracket 43 ± 6 4,3 ± 0,6
M10 x 80 Screw fixing pump water inlet pipe and support bracket 43 ± 6 4,3 ± 0,6
M10 x 30 Screw fixing the electric engine starter 43 ± 6 4,3 ± 0,6
M12 x 30 Screw fixing the sea water pump 85 ± 8 8,5 ± 0,8
M10 x 120 Screw for lower anchoring of the exhaust manifold 53 ± 6 5,3 ± 0,6
M10 x 150 Screw for lower anchoring of the exhaust manifold 53 ± 6 5,3 ± 0,6
N60 ENT M37 OVERHAUL
8.184
APRIL 2004
CHANGING THE ELECTRO-INJECTORS
(see Section 6)
FUEL SYSTEM PIPING
(see Section 6)
VENTING THE AIR FROM THE FUEL FEED LOOP
(see Section 6)
VALVES CLEARANCE ADJUSTMENT
(see Section 6)
REMOVE THE RING SEALING THE ENGINE’S DRIVING SHAFT FROM THE FRONT COVER
(see Section 6)
REMOVE THE HOLDING RING OF THE FLYWHEEL COVER BOX
(see Section 6)
FITTING FLYWHEEL HOUSING BOX
(see Section 6)
FITTING REAR GEARBOX
(see Section 6)