70159
70158
70160
70161
70162
Figure 1
Figure 2
Figure 3
Figure 4
The following instructions assume that the engine has
previously been placed on the rotating bench and that
removal of all specific components of the equipment have
been already removed as well. (See Section 3 of the manual
herein).
The section illustrates therefore all the most important
engine overhaul procedures.
The following operations are relating to the 4 cylinder engine
but are similar and applicable for the 6 cylinder.
Remove the screws (1) fastening the connecting rod caps (2)
and remove them.
Withdraw the pistons including the connecting rods from the
top of the engine block.
Remove the screws (1) and the main bearing caps (2).
The second last main bearing cap (1) and the relevant
support are fitted with shoulder half-bearing (2).
Use tool 99360500 (1) and hoist to remove the crankshaft
(2) from the block.
Remove the main half-bearings (1).
Remove the screws (2) and remove the oil nozzles (3).
Keep the half-bearings into their housings since in
case of use they shall be fitted in the same position
found at removal.
Take note of lower and upper half-bearing
assembling positions since in case of reuse they shall
be fitted in the same position found at removal.
Figure 5
ENGINE OVERHAUL
ENGINE REMOVAL AT THE BENCH
OVERHAUL
APRIL 2004 N60 ENT M37
8.157
Summary of Contents for N60 ENT M37
