http://www.itvsystems.com.ua
Integrated Technical Vision Ltd
19
- Access time is 20sec.
- Proximity cards types are ASK and FSK.
Changing engineer and master codes
Engineer code may be changed only in engineer code programming mode.
To change master code proceeds as follows:
In engineer or master code programming mode push
[0] [#]
, then introduce
[new
master code]
+
[#]
twice. The panel will turn to the highest menu layer. To go out
of programming mode press
[#]
button
.
New code will be admitted, if it does not coincide with already existing users' codes.
For example: To change master code
[7] [7] [7] [7]
in engineer programming mode
press
[0] [#]
(LEDs 1 and 2 blink red and LED3 blinks green synchronously), then
twice enter master code
[7] [7] [7] [7]
followed by
[#]
button pressing (LEDs 1
and 2 blink red alternately and LED 3 is off). Next
[#]
button pressing switches
panel to main mode (LED 2 blinks red).
Adding user code
To add user code do the following:
In programming mode push
[1] [#]
, panel indicates first free access code
number with the help of buzzer and LED 3.
Introduce
[
user code
]
+
[#],
then you can change code parameters or move to
the highest menu level (
[#]
button).
New code will be admitted if it does not coincide with already existing users' codes or
duress codes.
The following parameters are set for new code:
- door B access permission,
- has no outputs management permission,
- cannot switch day/night modes,
- 3 (third) code category.
Code parameters change is shown in the table.
Codes categories explanation.
To go out of programming mode push
[#]
button.
Code categories explanations are in table below:
Next
[#]
button pressing switches the panel to main mode.
For example: In is necessary to add [231964] code and set point A access for it and
and proximity card for accees through points A and B.
Using engineer code programming mode press
[1] [#]
(LED 1 blinks red and buzzer
and green LED 3 indicate vacant code number, then LED 1 and 2 blink red and LED 3
blinks green). Enter
[2] [3]
[1] [9] [6] [4]
[#]
code, panel proceeds with code
settings editing (LED 1 blink red and LED 2 blinks yellow alternately). Press
[1] [#]
buttons (LED 1 blinks red and LED 3 blinks green), switch on green LED2 and
switch off LED3 by
[4]
and
[6]
buttons pressing, then press
[#]
(LED 1 blinks red,
LED2 blinks yellow).
Press
[#]
panel turns to upper menu level (LEDs 1and 2 blink red alternately, LED 3
is switched off).
Programming the panel in stand-alone use
