http://www.itvsystems.com.ua
Integrated Technical Vision Ltd
25
Attributes are important only for door sensor or RTE button type of inputs. The rest of
inputs can be programmed as
[0]
attribute.
For example: It is necessary to set input 2 as door B sensor.
In engineer code programming mode press
[1]
[8] [#]
(red LEDs 1 and 2 blink
synchronously). Press
[2] [#]
(red LED1 and yellow LED2 blink alternately), now
press
[1] [#]
(LED1 blinks red, buzzer and LED3 reflect current input 2 type
setting). Press
[#]
to proceed with input type editing (red LED1 and green LED2
blink synchronously). Press
[1]
[8] [#]
, new value is accepted (red LED1 and
yellow LED2 blink alternately). Press
[2] [#]
(red LED1 blinks, buzzer and green
LED3 reflect current input 2 attribute setting). Press
[#]
to proceed with input
attribute editing (red LED1 and green LED 2 blink synchronously). Press
[1] [#]
,
new value is accepted (red LED1 and yellow LED2 blink alternately).
To proceed with other inputs programming press
[#]
(red LEDs 1 and 2) blink
alternately). to move to upper menu level press
[#]
(red LEDs 1 and 2 blink
alternately, LED3 is off).
To exit programming mode and switch the panel to programming mode press
[#]
(LED2 blinks red).
40 seconds pause between digits entry causes panel switching to main mode.
Programming Outputs
Press
[1] [9] [#]
in programming mode and enter [output number] +
[#]
. Then you
can proceed with outputs' type
[1] [#]
, attribute
[2][#],
time
[3] [#]
or mode
[4] [#]
programming.
Output type
Press
[1] [#]
after you have chosen number of the output, the panel reflects
current output type by means of buzzer and LED 3. The panel switches to output
programming mode after
[#]
button pushing. To introduce new settings press
[*]
then enter [type number] (from 0 to 3) +
[#]
.
Outputs' types
[0]
- output is not used
[1]
- lock, output is activated at valid code entering or valid card passing
[2]
- bell, output is activated when access point switches to blocked mode
[3]
- alarm, output is activated when access point switches to blocked mode
If you set the same type for two outputs (e.g. two bell outputs), then only the output
with the minor number will be assigned the set type.
Output attribute
Press
[2] [#]
after you have chosen number of the output, the panel reflects
current output attribute by means of buzzer and LED 3. The panel switches to
output programming mode after
[#]
button pushing. To introduce new settings
press
[*]
then enter [attribute number] (from 0 to 1) +
[#]
.
Outputs attribute
[0]
- door A,
[1]
- door B.
Attributes are important only for type 1 (lock) output.
Programming the panel in stand-alone use
