19
c
a
10
10
DIN 74-Af4
a: Distance between Linear Units
c: Length of conduit elements for covering the
Synchroniser Shaft
KLE 6 60x60: c = a - 24 mm
KLE 8 80x80: c = a - 32 mm
Afterwards, slot the cable conduit section into position be-
tween the synchroniser Adapter Plates at a slight angle.
By carefully selecting the position of the screw-attached
Adapter Plate, you can screw the cable conduit in place to
ensure an optimum position for opening the Lid.
Prepared KLE Drive Set
Scenario 2:
If a guard is fitted to provide protection against the rotating
Shaft, the cable conduit required is first sawn to the correct
length and then machined.
The rotating parts of the Synchroniser Shaft are covered
by a Conduit Profile U 60x60 E with Lid Profile D 60 E or a
Conduit Profile U 80x80 E with Lid Profile D 80 E.
Assembling Drive Set KLE 6 60x60 AP/WP 40 – 0.0.673.29
Assembling Drive Set KLE 6 60x60 AP/WP 60 – 0.0.673.28
Assembling Drive Set KLE 8 80x80 AP/WP 60 – 0.0.673.26
Assembling Drive Set KLE 8 80x80 AP/WP 80 – 0.0.673.27
This section describes the assembly of the Drive Sets of the KLE 8 80x80 and
KLE 6 60x60, which are prepared for item drive components, gearboxes and
motors. Due to the performance range of the KLE 8 80x80 and KLE 6 60x60,
two motors and two gearboxes with different output ranges are available and
can be connected with the linear axis using Drive Sets that have been prepared
appropriately.