1A-196 Engine Control System
5. Turn off the idle position switch for not less than 1
second but not more than 3 seconds. (Press the
accelerator pedal.)
6. After the above operations are properly completed,
the CHECK ENGINE lamp (MIL) illuminates for 3
seconds to report the memory is cleared.
7. Turn off the starter switch. Wait for 5 seconds and
turn on the starter switch again.
When Tech 2 has been connected to the vehicle, the
DTC can be cleared through the memory clear
operation with Tech 2.
Diagnostic Aids
Poor connection or damaged harness may cause
intermittents. Check for the following conditions and, if
the fault is detected, repair or replace the faulty portion.
• Poor connection at ECM: Inspect harness
connectors for backed-out pins, improper mating,
broken locks, improperly formed or damaged pins,
and poor pin-to-wire connection.
• Damaged harness: Inspect the wiring harness for
rubbed-through wire insulation or wire broken
inside the insulator. If the harness appears to be
OK, observe the display on Tech 2 while moving
connectors and wiring harnesses related to the
sensor. A change in the display will indicate the
location of the fault.
Step
Action
Value(s)
Yes
No
1
Perform the "On-Board Diagnostic (OBD)
System Check".
Was the OBD System Check performed?
—
Go to Step 2
Refer to OBD
System Check
and go to Step 2
2
Check the SCV connector for installation and,
if mounted improperly, install the device
certainly.
Is the action complete?
—
Go to Step 3
—
3
Review the DTC.
1.
Using Tech 2, check and store the DTC.
2.
Clear the DTC.
3.
Perform test run and review the DTC.
Is DTC217 detected?
—
Go to Step 4
Refer to
Diagnostic Aids
4
Check the SCV drive circuit for +B short.
1.
Starter switch "OFF".
2.
Disconnect the ECM.
3.
At the ECM connector pins, measure the
resistance.
Was the resistance within range?
Pins 80/81/
74/75-109/
114/115/116:
∞
Ω
Go to Step 5
Go to Step 6
5
Repair or replace the faulty harness.
Is the action complete?
—
Verify repair and
go to Step 11
—
6
Check the SCV.
1.
At the SCV connector pins, measure the
resistance.
Was the resistance within range?
8
Ω
Go to Step 9
Go to Step 7
7
Replace the supply pump (SCV).
Is the action complete?
—
Verify repair and
go to Step 8
—
8
Check DTC217 will not be set again.
1.
Restore the vehicle.
2.
Using Tech 2, clear the DTC.
3.
Bleed the air from the fuel system
4.
Perform test run and review the DTC.
Is DTC217 detected?
—
Refer to
Diagnostic Aids
and go to Step 2
Repair is
complete
Summary of Contents for 4HL1
Page 267: ...No LG4HL WE 0229DOM...
