Engine Control System 1A-207
When Tech 2 has been connected to the vehicle, the
DTC can be cleared through the memory clear
operation with Tech 2.
Diagnostic Aids
Poor connection or damaged harness may cause
intermittents. Check for the following conditions and, if
the fault is detected, repair or replace the faulty portion.
• Poor connection at ECM: Inspect harness
connectors for backed-out pins, improper mating,
broken locks, improperly formed or damaged pins,
and poor pin-to-wire connection.
• Damaged harness: Inspect the wiring harness for
rubbed-through wire insulation or wire broken
inside the insulator. If the harness appears to be
OK, observe the display on Tech 2 while moving
connectors and wiring harnesses related to the
sensor. A change in the display will indicate the
location of the fault.
Test Description
Number(s) below refer to the step number(s) on the
Diagnostic Chart.
3. If the DTC is not detected, the possible cause is
intermittent (intermittent fault).
Step
Action
Value(s)
Yes
No
1
Perform the "On-Board Diagnostic (OBD)
System Check".
Was the OBD System Check performed?
—
Go to Step 2
Refer to OBD
System Check
and go to Step 2
2
Check the idle position switch for mechanical
fault.
1.
Check the idle position switch connector
for installation and, if mounted improperly,
install the device certainly.
2.
Check the contact between accelerator
pedal and switch and recondition the
improper contact, if any.
3.
Press the idle position switch with a finger
to check the sliding performance. In case
of unsmooth movement, blow air against
the switch to remove foreign materials.
Is the action complete?
—
Go to Step 3
—
3
Review the DTC.
1.
Using Tech 2, check and store the DTC.
2.
Clear the DTC.
3.
Perform test run and review the DTC.
Is DTC242 detected?
—
Go to Step 4
Refer to
Diagnostic Aids
4
Check the display on Tech 2.
1.
Starter switch "ON", and display the
engine data.
2.
Observe the "Idle Position Switch" display
while operating the accelerator pedal.
Is the idle position switch turned on and off
according to the pedal operation?
—
Go to Step 10
Go to Step 5
5
Check the idle position switch.
1.
Starter switch "OFF".
2.
Measure the resistance between the idle
position switch connector pins while
operating the switch with a finger.
Was the resistance within range?
Switch-on
(switch is
released):
50
Ω
, max.
Switch-off
(switch is
pressed):
∞
Ω
Go to Step 7
Go to Step 6
6
Replace the idle position switch.
Is the action complete?
—
Go to Step 12
—
Summary of Contents for 4HL1
Page 267: ...No LG4HL WE 0229DOM...
