Copyright 2021 Iron Bow Technologies
23
MedView Standby Mode
The system has been pre-configured to go into standby mode after a call is dropped, and
the camera will also move to the privacy position. The standby delay value can be
changed using the web interface of the codec (see
Error! Reference source not found.
under
MedView Administration
).
Waking Up the MedView
The factory preset default condition of the
MedView is that it is always awake. An image will
only be displayed on the screen when a call is
made/received.
When a call is active the “On-Air” indicator will
illuminate
Powering Off the MedView
Powering off the MedView is typically unnecessary. Most video endpoints remain
connected to the network and in stand-by mode until a call is placed or received. If you
need to move the MedView to a different location, simply disconnect and re-connect the
AC power, as needed.
Handling the MedV
iew
Care should be taken when handling the MedView if it is moved to a different location,
mounted on a mobile cart as well as when cleaning. If the camera is manually moved
when the system is powered, it is no longer aware where it is pointing. This creates a
fault condition where the camera will not move correctly, or at all, when being controlled
from the local or far end, as well as returning to its standard or privacy position.
Figure 21 – “On-Air” Indicator
Figure 22 – Camera Fault Condition Indicator
