MK-100151 Rev. A
26
E NG LI S H
S. DYNAMIC MONO BACK (ELASTOMER REPLACEMENT)
There are four Elastomer stiffnesses available. Two types are provided with your chair. If your Elastomer gets
worn out, or you need a different level of support, you can replace the elastomer with a few easy steps.
IMPORTANT NOTE– DO NOT change the elastomer with the rider in the chair.
a.
BEFORE changing out your Elastomer, transfer the user to a safe location while this task is performed.
b.
The elastomer inserts(A) can be changed out by using a 5/32” hex key on the upper Socket head
screw(B) and a 10mm socket and socket wrench for the Lower hex nut(C).
c.
Loosen and remove the nut and hardware on both sides of the chair that hold the Elastomer in place
on the lockout system
d.
Remove and replace the old elastomer.
e.
Rethread the Socket head screw from the top, thru the bracket and elastomer, and hold the nut with
your finger while turning the hex key to get the nut started.
f.
Finish the replacement by using the socket, socket wrench and hex key to tighten the elastomer hard-
ware to 60 in-lbs.
T. VENTILATOR HANGER BRACKET
1. Attach the ventilator to the ventilator bracket.
a.
Position the ventilator above the hanger bracket (D) and slide it into the bracket.
b.
Using the 2 nylon straps(E) (F) secure the Ventilator to the hanger bracket and make sure any cords
and tubes are secured and not in danger of pinching in any of the components of the chair.
U. FIXED STROLLER HANDLE
1. Angle Adjustment of the Stroller Handle
Depress both black push buttons (H) at the same time. This disengages the stroller handle and allows it to
rotate freely. Releasing the push buttons positively locks the adjustable stroller handle in the desired position.
2. Height Adjustment
a.
Remove both bolts (G) from the backrest tube (one on each side).
b.
Reposition backrest height.
c.
Re-tighten both bolts (I) in the desired location.
V. ADJUSTABLE STROLLER HANDLE (MONO BACK)
1. Height Adjustment
a.
Using a 5/32” hex key Loosen both screws ( I ) from the Stroller tube attachment clamp(H) (one on
each side).
b.
Reposition stroller handle height by sliding the assembly up or down in the channel.
c.
Re-tighten both screws ( I ) in the desired location.
2. Stroller handle to Push handle conversion
a.
Loosen both screws (Do not Remove) (I) from the Stroller tube attachment clamp(H)
b.
Remove the screws that hold the cap ( J ) to the Mono Back, Remove the endcap, and slide the brack-
ets up and off of the Mono back rail.
c.
Reposition the stroller handles in the push handle configuration (L)
c.
Re-tighten screws in both clamps once you have them in the desired location.
59
60
61
62
63
61
H
G
62
63
H
I
K
L
IX. DEALER SERVICE & ADJUSTMENT
59
B
A
C
60
F
D
E
J
