IREX Photovoltaic Module - Installation Manual
Hướng dẫn lắp đặt PV mô-đun IREX
26
3.5.2. Framed modules with clamp /
Tấm pin có khung được lắp bằng phương
pháp kẹp
Using suitable module clamps on the side of the module frame to mount
the modules, we suggest installer use the long side of the module frame. When
using clamps to clamp the module frame, the area of side of module frame clamped
by each clamp shall be no less than 400 mm
2
.
Sử dụng kẹp thích hợp ở bên cạnh của khung để gắn kết các tấm pin, chúng
tôi đề nghị lắp đặt phía cạnh dài của khung. Khi sử dụng kẹp, diện tích cạnh của tấm
được kẹp bởi mỗi kẹp sẽ không nhỏ hơn 400 mm
2
.
The modules should be fixed to the structure using M8 stainless steel
hardware together with corrosion-proof clamps on the long side. The clamps must
be mounted at the position of the mounting hole or IREX suggested clamp range
and numbers.
Các tấm pin nên được cố định vào cấu trúc bằng cách sử dụng các vật
liệu bằng thép không gỉ M8 cùng với kẹp chống ăn mòn ở phía cạnh khung dài. Các
kẹp phải được gắn ở vị trí của lỗ lắp hoặc IREX đề nghị phạm vi và số lượng kẹp.
Table III: Position requirements for Mounting Holes method
Bảng III. Vị trí yêu cầu của phương pháp dùng lỗ lắp đặt
The lower/normal level of load
conditions (2400 Pa) /
Điều kiện tải
bình thường (2400 Pa)
Use 4 mounting holes /
Sử dụng 4 lỗ
lắp đặt
The higher level of load conditions
(5400 Pa) /
Điều kiện tải cao hơn (5400
Pa)
Use 8 mounting holes /
Sử dụng 8 lỗ
lắp đặt
Summary of Contents for IRM72S1-400
Page 49: ......