Document: DOC000325-2.2
1
Copyright 2022: Novax Industries
IntelliCross
™
Touch-Free / Wi-Fi Kit
Installation Guide
IMPORTANT:
READ THE INFORMATION BELOW IN FULL BEFORE INSTALLATION.
REMOVE
BUTTON’S
POWER (7-PIN GREEN CONNECTOR) FOR 2MINS BEFORE INSTALLING TOUCH-FREE BOARD
Installation Steps:
1.
Attach the
1-inch Gasket
(in the same location as shown in the
picture), before attaching the Touch-Free/Wi-Fi card.
The Gasket will help align the Card and center the Sensors on
the Terminal Cover sensor holes.
-
(1-inch Gasket is included in the Kit)
2. Carefully insert the Touch-Free card with the 7-PIN and 5-PIN
HEADER aligned on top of the sockets. Start by aligning the front
pins. Then gently rock the board forward into position.
Gently Push Down on the Board with all the pins inserted to the
sockets.
Note how the board is seated in the blue boxes as shown.
Attached the 7-PIN (Green) Power connector.
3.
i) Push New Touch-
Free Card’s
terminal cover all the way in to the
Button’s lip, before pushing down
ii) Ensure the sensor holes are aligned with the Touch-Free Sensors and affix screws.
The IntelliCross Touch-Free Button accessory enables pedestrians to
activate a button request with a simple hand-wave and configure the
Button wirelessly thru Mobile App. Requires IntelliCross Button
Software v.1.2.5.3_1958 or higher and Configuration Program v1.4.0 or
higher.
