Workflows
This section contains the following sections:
•
(page 25)
•
(page 26)
•
(page 27)
Pre-Install Workflow
Pre-install for ioiboxes usage
1. Install video cameras.
2. Determine ioibox unit storage. Install boxes and associate equipment if needed.
3. Install electrical infrastructure (conduit, electrical wiring, boxes, breakers, grounded
outlets, switches, UPS, surge protector, grounds, etc.).
4. Establish or Install LAN/WAN network access for ioibox unit location (network wiring,
ports, wireless, WAP (Wireless Access Point), etc.).
5. Install wiring between interfaces to external devices (Relay Outputs, Dry contact Alarm
Inputs) and the ioibox location.
6. Install video monitors and the wiring to connect to the ioibox unit location.
7. Install wiring between PTZ controller leads and the ioibox unit location.
8. Connect the workstation computer to the network.
The unit is delivered from manufacture with a pre-configured IP
address. Change the pre-configured IP address to match your network IP
mapping before connecting the unit to the network.
It is possible to access the HTML Edition Setup menu in the unit by
connecting from a laptop/PC directly to the unit using a network cable and
typing the IP address on an IE web browser
Pre-install for stand-alone using only the analog video output
1. Install video cameras.
2. Determine ioibox unit storage. Install boxes and associate equipment if needed.
3. Install electrical infrastructure (electrical wiring, boxes, breakers, grounded outlets,
switches, UPS, surge protector, grounds, etc.).
4. Turn on the cameras, matrix switcher, monitors as well as any external devices
(connected to the units through Relay Outputs and Alarm Inputs).
25
