7
Pulsar extractor fan
•
Installation and operating instructions
2.1 Function
The Pulsar extractor fan is programmed to suit most
installations.
The following factory settings are pre-programmed:
• Control by exposure to light: If the light conditions
change, i.e. lights are switched on, the shadows change,
or a person enters the room, the fan starts with a flow
rate of approx. 60 m³/h and runs for 15 minutes. After-
wards, the Pulsar extractor fan is switched off again.
• Control by humidity sensor: If the humidity increases
strongly, for example when the shower is used, the flow
rate rises to a maximum of 95 m³/h. When the humidity
decreases, the Pulsar extractor fan is switched off again.
When the extractor fan is switched on for the first time, the
factory settings are active.
Additional control and configuration of the Pulsar is possible
via the inVENTer Mobile app.
If required, the Pulsar extractor fan can also be used as a
wall-vent fan for ventilation and heating of adjacent areas,
e.g. unheated rooms. The extractor fan turns on when the
selected temperature limit is exceeded. It switches off again
when the room temperature falls back within the selected
range.
The extractor fan is controlled and configured using the
inVENTer Mobile app.
You can download the app for free from
the Google Play Store (Android) or
the App Store (iOS).
Technical requirements:
• Mobile device with Android or iOS operating system
• Bluetooth Smart
The following additional settings and functions can be
changed via the inVENTer Mobile app:
• Flow rate
• Sensitivity of the humidity sensor
• Sensitivity of the light sensor
• Run-on time
• Power-on delay
• Boost function
• Intelligent pause function
• Interval mode
• Settings for continuous ventilation
• Temperature settings when used as a wall-vent fan
You can find out more about
the possibilities offered by
inVENTer Mobile and down-
load the app directly here:
www.inventer.de
SYSTEM OVERVIEW
