36
inVENTer Connect controller platform | Installation instructions
INSTALLING THE DEVICES
In order to be able to mount the inner cover, the wall sleeve and housing must be installed:
• Wall sleeve: The installation of the corresponding wall sleeve is not part of this documentation.
It can be found in the installation instructions for the respective ventilation device.
• Inner cover housing: See Section 4.4 of this documentation.
All work steps are identical for the flush-mounted (UP) and surface-mounted (AP) variants. Unless
otherwise described, the surface-mounted variant is shown.
Requirements:
• The wall sleeve and housing are installed and
provided with protective covers.
- Connect R-D160 UP/AP inner cover housing
2003-0245
- Connect R-D200 UP/AP inner cover housing
2003-0246
►
Remove the protective cover from the housing and
from the wall sleeve.
Access to the installation site is clear.
Snapping the holding plate with the electronics into the housing
Requirements:
• The housing and wall sleeve are freely accessible.
NOTE:
Malfunction of the ventilation
device due to damage to the electronics.
• Do not damage the electronic components
when inserting the holding plate!
►
Hold the holding plate at a slight angle and slide it
downwards into the guide provided in the housing
( ).
►
Swivel the holding plate towards the housing and
then gently press it into it ( ).
The holding plate should snap audibly into place.
1
2
1
CLICK
2
UP
AP
