Scorpius
Service Manual
1654773~A
53
2.13.2 SERVICE-13-2 Folding Unit Repair (Manual Only)
SERVICE-11 Rear Top Shroud Repair
SERVICE-12 Rear Lower Shroud Repair
SERVICE-11-5 Folding/ Unfolding Board Repair
steps, and when this has been done, then:
1. Locate the folding unit locking pins on each side of the bottom of the scooter frame.
2. Use a wrench (#17) to remove the locking pins.
3. Cut and remove the cable tie (x1 pc) on the frame and remove the steel cable.
4. Use a cross-head screwdriver to remove the screws (12 mm, 2 pcs) from the plastic shroud.
5. Use a cross-head screwdriver to remove the screws (20 mm, 2 pcs) that hold the folding unit.
6. Take out the entire folding unit set.
❖
When replacing parts or re-installing, carry out these steps in the exact reverse sequence but also follow
the re-installation instructions below.
Re-Installation Instructions:
For the folding unit re-installation cable wiring, please refer to the pictures on the right - pay particular attention
to the items shown in triangles.
Cable wiring needs to pass through the
middle of the motor.
A cable tie is necessary to hold the cable in
place.
The left folding unit locking pin (longer steel
cable) passes outside the sliding base.
