Scorpius
Service Manual
1654773~A
48
Remote Control Board Replacement
SERVICE-12-2 Remote Control Board Repair
1. Detach the battery connectors from the hooks on the rear lower shroud.
2. Remove the connectors from the remote control board.
3. Remove the remote control board main cable.
4. Remove the four screws (8 mm, 4 pcs) holding the remote control board in place.
5. Take the remote control board out.
❖
When reinstalling, carry out these steps in the exact reverse sequence.
❖
If function is not restored, refer to SERVICE-11-1 DR Controller Repair to replace it with a new one.
•
The remote control board can be set for a maximum of four remote controls
at the same time. When it is necessary to set more, erase the settings on the
remote control (instructions are on the previous page) and start the setting
again.
•
Older versions of the remote controller (see picture on the right) can only be
used for “remote control internal setting”. They will not work with “remote
control external setting”.