Scorpius
Service Manual
1654773~A
55
Re-Installation Instructions:
❖
Before re-installing the sliding tracks apply a little amount of oil to the holes
(see picture on the right) to facilitate folding and deployment.
2.13.4 SERVICE-13-4 Motor Repair
SERVICE-11 Rear Top Shroud Repair
SERVICE-12 Rear Lower Shroud Repair
1. Use a wrench (#13) to hold the nuts on the right side of the frame and an Allen driver (#5) to unfasten the
bolts (30 mm, 2 pcs).
2. Follow the same procedure for the other side of the frame.
❖
The motor is quite heavy, be careful not to drop it when taking it out.
3. Remove the U-shaped fixing plates on both sides, and the motor can be taken out.
❖
When replacing the motor follow the same sequence of steps in exact reverse.
2.13.5 SERVICE-13-5 Electromagnetic Brake Repair
, and then:
1. Remove the motor, and locate the four screws holding the electromagnetic braking device to the motor.
2. Use a cross-head screw driver to remove the screws and separate the device from the motor.
3. After it has been taken off, cut and remove the cable tie holding the brake cable to the motor cable.
4. Take off the electromagnetic braking device.
❖
When replacing the unit, follow the sequence of steps in reverse.
•
The motor is heavy, and this operation should be given the attention of two people. One can
support the motor while the other removes or replaces the bolts, etc. The scooter should be
turned over to make this operation easier.
•
After the motor has been removed, set it aside carefully and do not drop or damage it unless
it is to be discarded.
•
All the other parts, including the U-shaped fixing plates and the bolts and nuts need to be
kept because they will not be provided with a new motor.
