Scorpius
Service Manual
1654773~A
37
Spring Re-Installation Instructions
1. Spring location (Figure a. on the right): Long end to the left/ short end to the right.
2. Re-install at the locking pin on the left side of the footplate shroud.
3. Spring mounted into the locking pin on the left side.
4. For the rest of the re-
installation refer to Step 3 → Step 1 of
The footplate shroud should be lifted occasionally (without removal) so that the gears shown in Figure b. to
the right, can be lubricated. This is important and should be done regularly to prolong the useful life of the
scooter.
2.11 SERVICE-11 Rear Top Shroud Repair
1. Remove the two inner screws (12 mm, 2 pcs) underneath the rear top shroud.
2. Remove the rear footplate shroud by disengaging the three locking pins and pulling it upwards.
3. Take out the rear footplate shroud.
4. Remove the four screws (12 mm, 4 pcs) at the rear of the top shroud.
5. Raise the top shroud carefully.
6. Remove the three connectors on the inside of the shroud.
7. Take the shroud off.
❖
When reassembling, please follow the exact reverse sequence of these steps.
❖
For instructions about the connectors, refer to the content of the next page.
