Scorpius
Service Manual
1654773~A
49
2.12.3 SERVICE-12-3 Supporting Wheel Repair
Refer to
SERVICE-09 Front Lower Shroud Repair
SERVICE-10 Front Top Shroud Repair
SERVICE-12 Rear Lower Shroud Repair
, and after removing the above items, then:
1. Secure the two fastening points on the supporting heel and the rear frame.
2. and
3. Use an Allen key or wrench (#10) to remove the holding screws (14 mm, 2 pcs) on both sides.
4. Disengage from the gear on the front frame.
5. Take the supporting wheel off.
❖
When reinstalling, make sure to carry out these steps in the exact reverse sequence.
•
Set the four screws and the remote control board main cable aside carefully because these
parts are not included with a new board.
•
When making the installation be careful not to damage the terminal on the control board.
•
After the remote control board has been replaced, the RF remote controller that came with
the scooter will need to be set up again.
