31
md c:\temp
install.bat
8. Shut down and power off the system; then restart the system.
9. At the MS-DOS command prompt, type in the following:
flash
The following messages display:
Intergraph flash programming utility
Reading 782XX.ROM.
Programming flash EPROM
Flash EPROM updated.
Reboot the system by turning the power off.
Do not use ctrl-alt-del for rebooting.
10. Remove the diskette from the floppy disk drive; then power off and restart the system.
11. Press
DEL
when the following message displays.
Hit DEL if you want to run Setup
12. In the Default menu, click on the Optimal icon. Select Yes to load the values.
13. If you customized the BIOS for your system, change the necessary parameters to their
previous values.
14. Exit AMIBIOS Setup and restart the system.
15. If you have ISA boards or PC Card devices installed in your system, use the system BIOS
to reserve the necessary system resources.
Changing the System Boot Sequence
To change the system boot sequence:
1. Restart the system.
2. Press
DELETE
when the following message displays:
Press DEL if you want to run Setup
The AMIBIOS Setup Main Menu displays.
3. In the Setup menu, click the Advanced icon. A list of parameters displays.
4. Click the System Boot Up Sequence parameter. The Options menu displays, with a
choice of boot sequences. The default is C:, A:, which designates the system hard disk
drive (C:) as the initial boot device, followed by the floppy disk drive (A:).
