Intel
®
Server System R2000WT Product Family System Integration and Service Guide
69
•
Slide all 8x2.5” drive bay module(s) into the chassis (see letter ‘E’)
•
Secure the top side of each drive bay module with two fastener screws each (see letter ‘F’) (8 in/lbs
torque for each screw)
•
Carefully place the chassis on its side and secure the bottom side of each drive bay module with one
fastener screw (see letter ‘G’) (8 in/lbs torque for each screw)
•
Carefully return the chassis to its original position
Install drive bay retention bracket
•
Locate the drive bay retention bracket and screws
•
Carefully slide the drive bay retention bracket into the gap between the top of the drive bay module(s)
and the bottom of the drive bay sheet metal. (see letter ‘A’).
•
Secure the retention bracket with six fastener screws (see letter ‘B’). (8 in/lbs torque for each screw)
•
Connect a power cable to each of the hot swap backplanes
Note: if installing a RAID expander card, do NOT attach the power cable to the middle hot swap backplane.
This will be attached at a later time.
