Intel
®
Server System R2000WT Product Family System Integration and Service Guide
10
Insert 8 x 2.5” drive bay module
Figure 8. 8 x 2.5" Drive Bay Module Installation
•
Carefully unpackage the 8 x 2.5” drive bay module from the accessory kit
•
Slide the 8 x 2.5” drive bay module into the server chassis (see letter ‘D’).
•
Using two fastener screws on the top back edge of the drive bay, secure the drive bay to the chassis (See
Letter ‘E’) (8 in/lbs torque for each screw)
•
Repeat steps 1-3 for the second drive bay module (if applicable)
•
Carefully place the chassis on its side and secure each installed drive bay module with one additional
screw on the bottom of the chassis (see letter ‘F’). (8 in/lbs torque for each screw)
•
Carefully return the chassis to its original position
Install Drive Bay Retention Bracket
Figure 9. R2000WTxxx Drive Bay Retention Bracket Installation
•
Locate the drive bay retention bracket and screws
•
Carefully slide the drive bay retention bracket into the gap between the top of the drive bay module(s)
and the bottom of the drive bay sheet metal. (see letter ‘A’).
•
Secure the retention bracket with six fastener screws (see letter ‘B’). (8 in/lbs torque for each screw)
•
Continue to section 1.3.5
