Before you Begin
Before you
Begin
Connect
Hardware /
Connect Target
Device to Host
System
Put Runtime
Software on
Flash Drive
Prepare Host
System for
Wind River
Software
Register Target
Device
Install Linux
and Wind River
Packages on
Host System
Build Runtime
on Host
System
Update SPI
Firmware on
Target Device
Install Runtime
on Target
Device
Review the following information to make sure you have everything you need.
Required Experience Level
You need basic experience using the Linux command line interface.
Items and Software You Need to Provide
You will need to provide the following items to complete your installation:
Table 2.
Items to Obtain
What you need
First Needed in
Notes
USB keyboard
17
Host System hardware
(recommended):
• 3
rd
Generation Intel
®
Core
™
i5
processor or better
• CPU with four or more cores
and with Intel
®
Hyper-
Threading Technology
• 150 GB or more of free disk
space
• 4 GB or more RAM
• One USB 2.0 port
Connect the Target Device to a
on page 18
The minimum hardware
requirements are:
• Intel
®
Pentium
®
2 processor
• 80 GB free disk space
• 768 MB RAM
With these minimum
requirements, your performance
may not be adequate.
Host Operating System
Connect the Target Device to a
on page 18
The Wind River Systems, Inc.
development tools may be
installed on many different Linux*
based host systems. See
on page 15
These instructions have been
validated on an Ubuntu 14 64-bit
host system.
Communications:
• PuTTY utility or equivalent
• Serial to USB cable
Connect the Target Device to a
on page 18
USB flash drive with at least 4 GB
capacity
on page 49
The contents of this flash drive will
be overwritten.
Blank line. Do not delete.
Blank line. Do not delete.
Blank line. Do not delete.
1.5
Intel IoT Gateway Development Kit DK200 Series —Introduction
Intel
®
IoT Gateway Development Kit DK200 Series
Getting Started Guide
April 2015
14
Order No.: 330295-004
