Intel® Server D50TNP Family Integration and Service Guide
52
2.5
Memory (DIMM) Installation
The DIMM replacement procedure for a liquid-cooled module and an air-cooled module is different. Refer to
the appropriate sub-section for your specific module configuration.
The Intel® Server Boards D50TNP1SB and D50TNP1SBCR support standard DDR4, RDIMMs, and LDRIMMs. In
addition, the D50TNP1SB server board supports
Intel® Optane™ persistent memory 200 series modules
(also
known
as, Intel® Optane™ PMem)
.
DDR4 DIMM and Intel® Optane™ PMem will be commonly referred to as “
Memory module
” in the following
instructions.
Note:
The system requires that all memory slots be populated with either a memory module or a DIMM
blank. Pre-installed DIMM blanks should only be removed when replacing it with an actual memory module.
When removing a memory module from the system, it must be replaced with an equivalent device or a DIMM
blank.
Note:
See
Appendix B
for general memory population rules.
2.5.1
DIMM Installation for Air-Cooled Modules
Required Tools and Supplies:
•
Anti-static wrist strap and conductive workbench pad (recommended)
Figure 47. DIMM Blank Removal
1.
Remove the DIMM blank from the desired memory slot
•
Open the ejection tabs at both ends of the selected memory slot to lift the DIMM blank from the slot
(see Letter A).
•
Carefully remove the DIMM Blank from the system (see Letter B).