200R204-000
Innovx FastSwitch Ethernet Switch
3-1
Issue 2
Installation and Operation Manual
Chapter 3:
FastSwitch Configuration
Configuration Overview
Table 3-1
describes in brief the configurable Innovx FastSwitch options. FastSwitch configuration
is performed through the command line interface (CLI). You can execute CLI commands at a
HyperTerminal connection or through a Telnet connection. A brief overview of CLI is provided
below. For a detailed guide to Smart CLI, refer to
Appendix A, Application Guidelines
The FastSwitch command line interface is an interactive means of configuring the FastSwitch
through a Telnet session over the LAN or by typing commands at a VT100-compatible ACSII
terminal connected to the FastSwitch craft port. The CLI is a smart, controlled-access interface that
provides general and context-sensitive help, automatically expands abbreviated command or
subcommands and also anticipates any required command arguments. The CLI will prompt for any
required argument that is missing from a command line.
Smart CLI Quick Reference
•
Get context-sensitive command help by using the
?
character in the CLI command string.
•
Type
?
at the command prompt to view a description of IP and Utility commands (shown
below). If you are in User mode, some commands shown below will not display.
_______________________ Innovx FastSwitch Commands___________________
clear Reset functions
configure Configure system parameters
default Default configuration to factory values.
disable Turn off supervisor/admin commands
enable Turn on supervisor/admin commands
help Description of the command line interface and help system
ping Send ping to remote device
show Show system parameters
_______________________Utility Commands______________________________
batch Store and/or run commands in batch mode
exit Exit FastSwitch Command Line Interface
flash Copy flash files/select flash boot file
reboot Halt and perform a reboot
services Show/Enable/Disable HTTP, SNMP & TFTP Services
•
Execute each command string by pressing the
Enter
key (or <
cr
>).
•
Commands entered in the proper syntax and with all required parameters/arguments will take
affect immediately. If required parameters or arguments are missing from the command string,
you will be prompted for them individually.
•
Abbreviated commands are accepted at the command prompt.
Summary of Contents for FastSwitch
Page 61: ......
